AC Voltage Source

This block implements a sinusoidal AC voltage source.

This block represents an ideal AC voltage source that outputs a constant sinusoidal voltage regardless of the current flowing through the block. It is described by the following equation:

V_out = A * sin ( f * 2π * t + Φ * π/180 ) + V₀

Vout represents the voltage that is applied across the block (referenced to the - port).

Parameters

Voltage amplitude A [V]	The peak amplitude referred to the DC voltage offset of the signal expressed in volts
Frequency f [Hz]	Frequency of the signal expressed in hertz
Phase Φ [°]	The phase shift of the signal at t = 0 expressed in degrees
DC voltage offset V₀ [V]	The amplitude offset or bias of the signal expressed in volts

Electrical Ports

From top to bottom, the electrical ports are the positive and negative ports of the source respectively named p1 and n1

Characteristics

All the parameters of this block can be set to have their values come from a Simulink or HYPERSIM block inport by using the deep panel view