Supported Features

• Operate as an IEEE1588 master or an IEEE1588 slave node
• Supports IEEE-1588-2002 (PTP V1) and IEEE-1588-2008 (PTP V2)
• Supports all standard profiles:
  • Default (IEEE1588-2008 Annex J.3)
  • P2P Default (IEEE1588-2008 Annex J.4)
  • Power (C37.238 2011)
  • Power S (C37.238 2011 slave only)
  • Power 2 (C37.238 2014) - only supported on 32-bit Linux platforms (x86)
  • Power 2 S (C37.238 2014 slave only) - only supported on 32-bit Linux platforms (x86)
  • C37.238 2017 - not supported on 32-bit Linux platforms (x86)
  • C37.238 2017 slave only - not supported on 32-bit Linux platforms (x86)
  • Smpte (ST 2059-2)
  • Smpte S (ST 2059-2 slave only)
  • Telecom (G.8265.1 master only)
  • Telecom2 (G.8275.1)
  • Telecom2 S (G.8275.1 slave only)
  • gPTP (IEEE 802.1AS-2001)
  • gPTP S (IEEE 802.1AS-2001 slave only)
• Generate demodulated IRIG-B or 1PPS signal to synchronize external devices
• Can be synchronized by an external IRIG-B or 1PPS signal
• Implements best-master-algorithm defined in the IEEE1588 standard based on the configurable priority
• Supports virtual LANs (VLAN)
• Supports peer-to-peer and end-to-end delay mechanisms
• Starts the simulation aligned to the 1PPS reference (next second change)

The following operation modes are possible:

• Operate as an IEEE-1588 slave mode synchronized through the network by an external IEEE1588 master and one of the following options:
• Do not generate any external signal
• Generate an IRIG-B signal
• Generate a 1PPS signal
• Operate as an IEEE-1588 master node to synchronize external IEEE1588 slave nodes on the network and one of the following options:
• Do not generate any external signal
• Generate an IRIG-B signal
• Generate a 1PPS signal
• Operate as an IRIG-B slave node synchronized through an external IRIG-B signal and one of the following options:
• Do not perform any IEEE1588 operation
• Operate as an IEEE-1588 master node to synchronize external IEEE1588 slave nodes on the network
• Operate as an 1PPS slave node synchronized through an external IRIG-B signal and one of the following options:
• Do not perform any IEEE1588 operation
• Operate as an IEEE-1588 master node to synchronize external IEEE1588 slave nodes on the network

Limitations

• The Oregano Syn1588 PCIe card accepts demodulated IRIG-B004 or IRIG-B007 signals (3.3V) only.
• The Oregano Syn1588 PCIe card can generate IRIG-B007 or 1PPS signals (3.3V) only.
• It is not possible to use two Oregano Syn1588 PCIe cards on the same system.
• On 64-bits Linux platforms, the firmware version number must be greater than 808.