Documentation Home Page Hardware Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

OP5511 Front and Back Interfaces

LEGACY PRODUCT

Please note that the OP5511 is discontinued.

Front Interface

The front face of the module provides input connectors for the external high-voltage and high-current signals.

OP5511 Front Panel Connectors

ACurrent Sensors connectorConnects external device's high current input
BVoltage Sensors connectorConnects external device's high voltage input
CAuxiliary Outputs connectorProvides internal connection to reduce the wiring length when both current and voltage of a motor must be simultaneously sensed. It also allows users to connect the motor reference voltage to the simulator ground, if required.

Refer to OP5511 Connector Pin Assignments for connectors' pins assignment tables.

Back Interface

The back face of the module provides activity LEDs, power input connection and the low-voltage output connector to be connected to the real-time simulator.

The module requires a regulated ±15 volt power supply to be used. In order to reduce noise, a linear power supply is preferred. 

OP551 Rear Panel Connectors

AVoltage Sensors LED

The activity LED (green) turns ON at 2V, while the out-of-range LED (red) turns ON when the upper voltage limit of the selected range has been reached. Depending on the factory jumper setting, the LED will light at 50V, 100V, 200V or 400V.

BDB25 connector

The DB25 connector (B) outputs the ±10V voltage signals. These signals can then be connected to the analog-to-digital converters of the real-time simulator, such as the OP5340.

CCurrent Sensors LED

The activity LED (green) turns ON whenever a current above 200mA is detected, while the out-of-range LED (red) lights ON when the upper current limit of the selected sensor has been reached. Depending on the factory jumper setting, the LED will light at 5A, 10A, 15A, 25A or 50A.

D

Power connector

± 15 VDC
EPower LEDsLEDs light ON to indicate when power is functional.

Refer to OP5511 Connector Pin Assignments for connectors' pins assignment tables.


OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323
Follow OPAL-RT: LinkedIn | Facebook | YouTube | X/Twitter