HIL2GO-310 - Unpack and Verify the Content of the Box

HIL2GO bundle data card entitled “Meet your HIL2GO Bundle.”

IMPORTANT: The bundle data card contains your OPAL-RTLinux login credentials
Please make a copy of the card and keep the original in a safe place.

Starter Kit

Network cable, CAT 6, RJ45 connectors, 10 feet (3.05 meters)

Used to connect the simulator to your host computer via the local network, a network switch or direct connection.

Network cable, CAT 6, RJ45 connectors, 7 feet (2.1 meters)

Used to connect the OP5020XG simulator to the OP4810-IO FPGA processor and I/O expansion unit for bitstream flashing.

Flat DB9 cable, male/male, 1 foot (30.48 cm)

For DB9 serial I/Os

Loopback flat ribbon cable IDC40 to DB37M, 2 feet (0.61 meters)

The loopback board and cable can be used to connect anything to a DB37 I/O port of the simulator.

Loopback board DB37, 40 positions with Vuser

Rubber feet

Install four feet under each unit for tabletop use.

OP5980-2 diagnostic module, DB37M slim breakout board

These modules enable users to isolate individual pins originating from a DB37 connector, and to test for connections. We provide 8 modules, one for each DB37 connectors used:

• 2 for the digital I/O connectors: slot 1 - section A, connectors P1 and P2

• 1 for the analog out connector: slot 1 - section B, connector P3

• 1 for the analog in connector: slot 1, section C, connector P4

• 2 for the digital I/O connectors: slot 2, section A, connectors P1 and P2

• 1 for the analog out connector: slot 2 - section B, connector P3

• 1 for the analog in connector: slot 2, section C, connector P4

DB9M slim breakout board, male

These modules enable the user to isolate individual pins originating from a DB9 connectors, and to test for connections.

• RS422 Digital I/O, slot 3, section A and B (CH 00-05)

OP5020XG CPU-based real-time simulator

OP5020XG CPU-based real-time simulator

Refer to HIL2GO-310 - System Overview for hardware installed inside the chassis.

Cable assembly PCIe x4, male to male, 38 positions, 2 meters (6.56 feet)

Cable for PCIe communication between OP5020XG and OP4810-IO.

Power cable, 6 feet (1.83 meters)

Power cable compatible to your country’s power socket type.

OP4810-IO FPGA Processor and I/O Expansion Unit

OP4810-IO FPGA Processor and I/O Expansion Units

Refer to HIL2GO-310 - System Overview for hardware installed inside the chassis.

Power cable, 6 feet (1.83 meters)

Power cable compatible to your country’s power socket type.