Data Logger File Browsing with ScopeView

The ScopeView graphic window side ribbon allows navigating through data logging files.

From left to right, the controls are as follows:

Return to the beginning of the file
Show the previous frame
Go to the frame which corresponds to the parameters below
Show the next frame
Show the last frame

The parameters are as follows:

Trigger type
Start time	Start time of the frame to display.
Time length	Length of the frame to display.
	None	No trigger applied.
	Rising	Use a rising edge with the trigger value.
	Falling	Use a falling edge with the trigger value.
	High	Use the first value higher than the trigger value.
	Low	Use the first value lower than the trigger value.
Trigger signal	Signal used by the trigger option.
Trigger value	Value of the trigger threshold.
Trigger offset	Value of the time delay applied to the trigger value.
Time format	Absolute : The graph will show values from Start to Start+Time length Relative : Result will be shift result on the time axis, showing values from 0 to Time length.

Note that Trigger options in this window are independent of those set in the Data Logger Configuration. The ScopeView triggers apply to reading the file whereas the data logger triggers apply to writing the file.

The Time format option, used with the Trigger options, will help comparing signals from 2 oprecs, in case events happened at uncontrolled times during their recordings, such as the simtrig API command.

Note that the following table links the GUI Element Labels with the API call setDataPointParameter, so that users may understand how to access GUI parameters through API calls.

UI text	Api text
Time length	timeLength
Trigger Type	triggerType
Trigger signal	triggerSignal
Trigger value	triggerValue
Trigger offset	triggerOffset
Time format	triggerSignal