TestView Command | Main | Multi-Breaker

This command is used to program several groups of breakers in parallel. If the HYPERSIM network topology has previously been analyzed, all breakers from the model will be available in the dropdown menu in the selection section.

WARNING: This command must be in a loop before the HypProc command (Processing)

Function		Description
Title		To enter the name of the Multi Breakers command.
Category		Lists switches and breakers sub-categories. Example: hyDisjTerre is for faults hyDisjoncteur is for breakers
Name		Dropdown menu that lists all the breakers and faults found in the design.
Enable Ground		If the selected type includes g, this option is automatically updated.
Type		The user can select one or several default types. There will be as many iterations as default types under Group Tabs. The type suite adapts to the breaker Category and Name. For HyDisjoncteur: For HyDisjTerre:
Switching Times		Timing of the operation of the selected breaker or fault. This timing is relative to the Point-On-Wave synchronization. Up to 8 switching times can be configured. For more information on programming the breakers, look here.
Groups		The user must ensure that the number of circuit breakers in each group is consistent. In the example below, we see that each group has 5 default definitions:
Buttons	Add	Add an iteration using the configured switching time, the type, and the selected breaker defined. The iterations are relative to the Loop command. Consult this page for more info. note that you must enter at least one switching time to add an iteration. This button is only available when Group 1 tab is selected.
	Replace	Replace one or several iterations with another. You must select line(s) you want to replace. This button is only available from Group 2, therefore it is not available when Group 1 tab is selected.
	Disable	Disable iterations. You must select line(s) you want to disable within the current group. This button is only available from Group 2, therefore it is not available when Group 1 tab is selected. Disabling an iteration is equivalent to write "-" in the breaker column. In the example below, we see that the 3 latest iterations are disabled:
	Remove	Remove one iteration at a time. It will remove one iteration for all groups. If you remove Group 1, it will remove all Groups.
	Remove All	Remove all iterations for all groups.
		Move a selected iteration up or down the list.
	New Brk Group	Create a new Group. To remove a Group, right-click on the tab of the group you want to delete.