Introduction

The Analog Sensor card is used to provide to the ECU sixteen analog signals, simulating analog sensor outputs.  Each output signal can be adjusted within a voltage range specified by high/low reference voltages supplied to the card. 

Up to 10 ASM cards can be inserted in one OP6200 chassis, although the reference model typically uses a maximum of 3 cards.

The board also has the following capabilities :

• Selection of individual or common reference voltage
• Linear instead of ratiometric outputs
• Over-current and over-temperature fault conditions management

The board  also supports the following features, which are common to all OP6200 I/O boards :

• Over-temperature detection
• Battery voltage compatibility
• Module information
• Activity and status LEDs
• Firmware Update
• Synchronization
• Cable Identification

Architecture Overview