HIL2GO-310 - OP4810-IO I/O Channels Assignment

The following section shows the relationship between the I/O blocks in the RT-LAB model and the signal conditioning modules installed on the OP4810-IO expansion unit.
They are divided by slots (also named groups) and sections, and each is clearly identified in the illustrations.

The following I/O block mapping is provided with your system. It shows the specific pin assignment on standard DB37 or, DB9 connectors for the system and bitstream delivered.

Nomenclature correspondence between Simulink I/O blocks and OP4810-IO I/Os
Simulink blocks I/O nomenclature	OP4810-IO I/O ID nomenclature
Slot (1, 2 or 3)	Slot/Group (1, 2 or 3)
Module (A, B or C)	Section (A, B or C)
Subsection 1 (SS1)	Pin ID 0 to 7
Subsection 2 (SS2)	Pin ID 8 to 15
Subsection 3 (SS3)	Pin ID 16 to 23
Subsection 4 (SS4)	Pin ID 24 to 31

The RT-LAB’s Simulink blocks used to access the OP4810-IO I/Os use the following ID nomenclature:

SlotX.ModuleY.SubSectionZ.

To map the Simulink ID to the physical I/Os in the O4810-IO (rear panel), the user is advised to use the nomenclature correspondence in the table above.

For example, in Simulink, Slot1. ModuleA. Subsection3 is equivalent to Slot 1.A.(16-23) on the OP4810-IO expansion unit.

Slot (Group) positions

The illustration below shows the arrangement of the subsections of signals for the DB37 and the DB9 connectors.