1.1 Configuring the Real-Time Controller

To run a simulation, the VeriStand project must be configured to point to the real time controller. Please see the Hardware Requirements and Deployment Target Software Requirements for a list of supported real time controllers and operating systems.

In the tab for the System Definition File (.nivssdf), click Configure... to open the VeriStand System Explorer.
Click the Controller item in the System Definition tree.
Under Target Specification, input the IP address of the real time target to be used to run the real-time simulation.
If permissions are configured on your Real Time target, enter the credentials in the Username and Password fields. National Instruments targets are programmed with the following credentials by default:

Username: admin Password: <blank>