1.5 Configuring the Switches of the Model

Next, we will route a signal to each switch in the circuit model. For more information about the circuit model switches, please refer to the Switches section.

In the Configuration Tree, expand Circuit Model >> Switches. Note that a VeriStand channel has been created for each Switch component in the circuit model.
Click the Switches section to open the configuration page.
Confirm that the switch mappings are configured as shown in the image below.
Click Save.

The Custom Device Channels corresponding to each switch (SW01, SW02, etc) are mapped to their corresponding circuit model Switch (Diode 1, Diode 2, etc.). Note that because these Switches are diodes, their states are not controllable and their mapping configuration settings do not affect the simulation.