Page Content

Hardware Setup

This tutorial is written for an OP5600 simulator with a configuration 9 bitstream, but may be used with other types of simulators or firmware by substituting the correct I/O groups and configuration files.

Analog Loopback

Loopback components have been provided with your simulator. Assemble them as shown here to complete the analog loopback cable.
Analog loopback cables are useful to test inputs and outputs before connecting the simulation to an external device. It helps validate the voltage levels programmed and the integrity of the various signals by directly reading the signals sent.

Open

At the back of the simulator, connect both ends of this cable to group 1, slot A, connector P1 (analog output) and group 1, slot B, connector P1 (analog input) as shown here:

Open

Connecting the loopback kit for analog signals

Digital Loopback

The digital loopback requires one more component, a Molex 4-pin cable connected to a 4-30 VDC power supply.

Connect the end with the Molex cable to group 4, slot B, connector P1 (digital output) and the other end to group 4, slot A, connector P1 (digital input).

Then connect the power supply into the wall outlet.