Section Content

Open

The OP8110 4-Quadrant Power Amplifier is the heart of the OPAL-RT line of OP1400 Series test benches. It is an ultra-compact (2U) 4 Quadrants – 3 or 6 output – Power Soft-Switching Amplifier. The OP8110 can operate in both DC and AC modes with a bandwidth of 10 kHz with a low noise floor, high slew-rate, and low harmonic distortion.

The OP8110 can be directly controlled by OPAL-RT’s simulation platforms through a high-speed fiber-optic SFP link, enabling it to emulate many different operating configurations such as:

• 3-phase 0 to 208V_L-L,RMS

• 3-phase 0 to 415V_L-L,RMS

• Single phase 0 to 120V_L-L,RMS or 0 to 240V_L-L,RMS

• 0 to 400V_DC bus OR 0 to -400V_DC

The power level and number of simultaneous outputs differs between the OP1400/OP1420 test bench configurations, providing ample flexibility in selecting a suitable hardware platform for a wide range of application needs. The OP8110 is suitable for installation in any typical laboratory environment, featuring forced ambient air cooling with variable-speed fans along with both hardware and firmware-based protections to safeguard it from improper input/output connections (including short-circuit/over-current conditions and over/under voltages) as well as over-temperature conditions.

The OP8110 amplifier comes in two different variations depending on the number of outputs included:

• OP8110-3 (3 outputs)

• OP8110-6 (6 outputs)

Three amplifier outputs (L1, L2, L3) and their associated neutrals (N1, N2, N3) form one output group.

Therefore, the OP8110-3 has one output group – Group 1 whereas the OP8110-6 has two output groups – Group 1 & Group 2.

Open

OP8110-3 rear panel