Description

This block performs the communication with the FPGA in order to send the Analog Input Differential Rescaling Block its gain/offset configuration.

Mask Parameters

LoadIn port number: This parameter should reflect the communication port used to send scaling and offset information. Refer to the firmware documentation to know how to set this parameter.

Controller Name: Binds this block to an OpCtrl block by entering the same 'Controller Name' as specified in the OpCtrl block The OpCtrl block controls initialization of the settings of one specific card in the system.

Inputs

Gains: Each element of this input corresponds to the gain applied to one analog input channel. Its width must be equal to the number of channels that need to be processed.

Offsets: Each element of this input corresponds to the offset applied to one analog input channel. It is applied after the signal gain. Its width must be equal to the number of channels that need to be processed.

Mins: Each element of this input corresponds to the min output value applied to one analog input channel. Its width must be equal to the number of channels that need to be processed.

Maxs: Each element of this input corresponds to the max output value applied to one analog input channel. Its width must be equal to the number of channels that need to be processed.

Outputs

Status: This parameter reports the status of the LoadIn function. Refer to the LoadIn block within the RT-LAB I/O library to get the signification of the different status codes.

Characteristics and limitations

This block has no special characteristics.

If you require more information, please contact https://www.opal-rt.com/contact-technical-support/.