Documentation Home Page ◇ eHS Toolbox Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.
Dual PMSM Motors VDQ Advanced Command
Block
Table of Contents
- 1 Block
- 2 Description
- 3 Inputs
- 4 Outputs
Description
This block provides a way to change values sent to the FPGA during the execution of the simulation.
With the VDQ model, this block allows the user to:
Update Ra, Rb and Rc values
Force Ld and Lq values
Force Id and Iq values at the table Input
Force the theta angle to a position
Update the cut-off frequency of the Vabc monitoring filter
Force the flux value
The purpose of this block is to concatenate the values in a standard bus signal which can be read by advanced command capable blocks such as the PMSM VDQ model block.
Inputs
Inputs of this block should always be constants block.
Using the RT-LAB variable monitor, it is possible to change the values send to the FPGA by changing the constants values.
Outputs
The output must be connected to an advanced command capable block port.
An example is the PMSM VDQ model block.
If you require more information, please contact https://www.opal-rt.com/contact-technical-support/.