Block

Mask

This Biss-C Master Packing block recovers the data from the I/O controller block and generates the signals needed by the DataOut block.

This block has no parameters.

Ready	Signal received from the Biss Master. It indicate that the Biss Master configuration is done.
NER	Signal received from the Biss Master. It indicates "Error message" when NER is in low state.
Status_information1	Status Information 1 when NER = 0 (see Biss Master for further details).
Status_information2	Status Information 2 when NER = 0 (see Biss Master for further details).
Instruction_register	Data received from the Biss Master. It contains the value of the instruction register.
PositionValue	Data received from the Biss Master. It contains the position value of the Biss-C Slave.

DataOut	This signal contains the data of an analog subsection and a valid bit. It is meant interfacing the DataOut block.
DataSync	This signal represents a pulse to indicate the update of the DataOut port. It is to be connected to the DataSynci input port of the DataOut block corresponding to the channel selected for the DataOut signal.

This block has no specific characteristics or limitations.